HP ScanJet N6310 review

To test the scanner, we started by scanning a 10-page single-sided text document from the ADF at 300ppi into the ReadIRIS OCR, which took just 29 seconds to scan – though longer for the OCR to do its work. A 10-side duplex scan took three minutes to complete, even though it was being scanned to PDF without character recognition. Each page makes three passes through the scanner, but this does mean the scanned document remains collated.

We then scanned a 15 x 10cm photographic print at 600dpi, which took just over half a minute and finally a 35mm transparency at 2,400ppi, the maximum resolution of the scanner. This resolution is needed if you, for example, want to enlarge a 35mm transparency to a 300dpi, 10 x 8in (roughly A4) print. This would require image dimensions of 3,000 by 2,400 pixels.

When scanning high resolution, the ScanJet N6310 doesn’t excel on speed. It took 5:20 to make the transparency scan, quite a bit longer than the average dedicated slide scanner, so if you have a lot of transparencies to scan, a slide scanner would be a better option.

As for the quality of the scans the machine produced, text scans were adequate for both PDF creation and OCR and the colour image scans we produced at low and high resolutions showed good colour reproduction of business graphics and photo images. The scanner is well equipped to be used for small-scale archival work, using either compressed page images or recognising the text and storing it in the form of a searchable PDF.

HP is trying to widen the scope of business scanners with the ScanJet N6310, to deal with changing requirements, particularly increased emphasis on photo scanning. It has managed this pretty well and with the quality and speed of the scans we produced, this scanner is well worthy of consideration. It’s not a production scanner, though, and you should think in the 100-300 pages per day range as a target.